Lithofin kf stain stop 1 litre Expand

Lithofin kf stain stop 1 litre

LFKSTNST01

New

We shipping Australia wide

Fast delivery

Order over the Phone 0297080322

Order by email sales@casamarble.com.au

Lithofin kf stain stop

This ready-to-use special impregnator is solvent based and contains high quality water and oil resistant components.

Properties Lithofin KF Stain-Stop penetrates into the surface and coats the capillaries with an extremely thin, invisible film. Oil, grease and water are not absorbed by the surface, but instead remain on the surface. During this time, dirt can easily be removed without leaving stains. The effectiveness depends on the amount of product absorbed by the surface. The characteristic appearance of the surface material is not or only slightly altered.

Technical Data: Density: approx. 0,78 g/cm³ Appearance: liquid, colourless, clear Odour: aromatic pH-Value: n.a. Flash Point: approx. 23°C Reduction in Water Absorption: 90 to 95%

Field of Use For protecting unglazed ceramics against stains and for facilitating every-day maintenance. Highly recommended for use in kitchens, bathrooms and other areas which may come into contact with water and oil. Please Note: Lithofin KF Stain-Stop does not or only slightly affect the slip resistance properties of the surface.

Directions for Use The surface to be treated must be completely dry and clean.Always test the product in an inconspicuous area prior to use. Areas should be treated in sections of approx. 10 to 15m². On highly absorbent surfaces: evenly and generously apply Lithofin KF Stain-Stop with a brush or roller. Avoid foam. On less absorbent surfaces: use a brush or a cloth. After approx. 20 minutes, apply Lithofin KF Stain-Stop again to ensure that the entire surface is saturated. Then carefully remove all surface residues with a cloth. On large areas use a polishing machine with a white pad. Do not allow any product to dry on the surface. On highly absorbent surfaces, a second application after approx. 24 hours may be necessary. Attention! the liquid product must sink into the surface. Do not allow the product to dry on the surface. Dry residues will not be removable once product is fully cured. Always try the product in an inconspicuous area prior to use. Lithofin KF Stain-Stop can only be used on absorbent and completely dry surfaces. Glass, ceramics, wood, and other surfaces sensitive to solvents must be protected against splashes. Application Temperature: the temperature of the surface should be between 5°C and 25°C. Switch off under floor heating. Drying Time: most solvents will evaporate within two hours. The product will be fully effective after approx. 48 hours.

Suitable for:Porcelain and Ceramics
PackageSingle
Milliliters501 - 1000 ml
Path: > > > Lithofin kf stain stop 1 litre
Accept Site use cookies